Symetrix AXIOMTEK 10.4 Touch Panel PC Manuel d'utilisateur télécharger pdf (Page 52)

GOT-5100TL User’s Manual

Phoenix-Award BIOS Utility

3.13 Set Supervisor/User Password

You can set a supervisor or user password, or both of them. The

differences between them are:

1. Supervisor password: You can enter and change the options on

the setup menu.

2. User password: You can just enter, but have no right to change

the options on the setup menu.

When you select this function, the following message will appear at the

center of the screen to assist you in creating a password.

ENTER PASSWORD

Type a maximum eight-character password, and press <Enter>. This

typed password will clear previously entered password from the CMOS

memory. You will be asked to confirm this password. Type this

password again and press <Enter>. You may also press <Esc> to abort

this selection and not enter a password.

To disable the password, just press <Enter> when you are prompted to

enter a password. A message will confirm the password is getting

disabled. Once the password is disabled, the system will boot and you

can enter Setup freely.

PASSWORD DISABLED

When a password is enabled, you have to type it every time you enter

the Setup. It prevents any unauthorized persons from changing your

system configuration.

Additionally, when a password is enabled, you can also require the

BIOS to request a password every time the system reboots. This would

prevent unauthorized use of your computer.

You decide when the password is required for the BIOS Features Setup

Menu and its Security option. If the Security option is set to “System”,

the password is required during booting up and entry into the Setup; if it

is set as “Setup”, a prompt will only appear before entering the Setup.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 64 65

Pas de commentaire

Symetrix AXIOMTEK 10.4 Touch Panel PC Manuel d'utilisateur Page 52